Plantation shutters Brisbane are a great way to add a sense of luxury to your home. One of the first steps in installing blinds is to properly measure the windows that are designed to do so.
If you follow the steps, you must keep in mind whether the shutters are mounted inside the window frame or outside. Measurement techniques vary.
It is also important to consider the rear space as it will provide space for the blindness and operation of the blinds. Make sure there is also room for hand cranks, shaping, cutting and even the window itself.
Create a window square
Make a diagonal window in all directions. If there is a difference in the diagonal dimensions, your window is not square.
If the difference is less than ¼ per inch, then you should be fine, but anything between ¼ and ½ is considered non-square and more than ½ inches is non-square.
The angle of the built-in window will affect the type of frame and bracket you need to choose for plantation shutters.
Inside the shutters of the mounting plantation
Measure the length and trim inside the plasterboard or paneling where the plantation internal shutters are mounted. It is important to consider whether the drywall or trim is narrower back to the window opening.
If this happens, you will want to take a narrower measurement to find out where the blinds need to be placed. It is important that you measure the actual window opening and do not make any cuts when measuring the internal blinds.
The factory will make the blinds slightly smaller than the dimensions you supply, so exact dimensions are important. You must circle to the nearest 1/16 “. For example, if the size is between 3/16” and 1/4 “, circle to 3/16”. Shutters will not fall during installation. Use the shortest length and narrowest width when ordering.
Outside the shutters of the mounting plantation
There are a few things to consider when placing hatches outside the frame. Start by deciding what area you want the blind to cover, don’t go to the window itself.
Also decide if you want the shutter frame to be mounted on plasterboard, on top of the paneling or on the outside of the paneling. Follow the same diagonal, vertical, and horizontal procedures as above, but use the area to cover the outside as the start and end points.
Plantation shutters Brisbane will not take any deductions from your measurements of outdoor plantation shutters. To learn more about this topic visit our website.